What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 17.06.2025 07:12

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
So, the voltage could go up to 500 volts, and the fuse will not open up.
The MOV will conduct when the voltage exceeds 50% of line voltage.
What is your most intimate experience with your best friend?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Now when you have a certain ac resistance, then a current flows in a loop.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
There are three different concepts here that are getting confused.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Barnstars:
What does a fuse do?
but I think this circuit , shows a few more pieces.
A fuse is a non-resetable over current circuit protector.
How did you respond to, "Why do you love me"?
The other is “what does a “fuse” do?”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
what exactly is a ‘surge’ protector?
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This is where the MOV conducts again, and dissipated the energy.
These are simplified answers to the original question, and does not change anything I wrote above.
Edit 2024–10.
At one ohm, the resistor has a maximum of 1 watt power.
Why is dating so frustrating and difficult for a guy?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–14 [Omar Gharbi Omar Gharbi ]
A circuit breaker is similar, but is resettable.
Is TikTok becoming a platform for soft porn?
But it can get overloaded, and no longer works.
eight
At least they know the answer if they wanted it.
What are some difficulties in a JEE aspirant's life?
Because the load is inductive, the current lags the voltage.(by a bit).
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Why do subpar women think that they are nines and tens?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This device then solves the entire problem.
The third is lightning and “how it gets conducted into a home.”
If sea levels were rising, wouldn't the acreage of coastal salt marshes increase? Are they?
These devices are installed between the “hot” and “neutral” and protective ground.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
For this case there are devices called Metal oxide varistors (MOV).
The bolt then partially travels down the line to your home.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This one hit behind the barn.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
One
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
What is lightning?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
In schematic diagrams this is the symbol for a fuse:
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
nine
Here is a simplified AC power diagram.
But… the neutral is now “floating” because of the 1 ohm resistance.
so, what happens?
This is 'the assistant's answer'
It seems Mohan does not understand the difference between a comment and an Answer.
He then describes Rainy Season and Lightning.
I post the exact comment here.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
[old diagram got deleted by accident]
but this device (an Inductor) … impedes the rapid changes in the current.
He then asserts :
One is “what exactly is in a ‘surge protector’ ? ”
(Dc diagram shown, AC is similar).
It also is a device that limits the change in current flow.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
An AC voltage/ current source, and an ac inductive load.
the problem then depends on "how fast does the fuse operate?".
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
First Sentence:
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–16 [ OO OLAOYE OYEBODE ]
[image of Common-mode choke]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
He then describes the function of a fuse.
Upvotes:
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
There are two important concepts here.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
a photo is worth a thousand words.
2024–10–10[John johnson John Johnson ]
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is where this question deviates from being a 'generic' question, and becomes more specific.